Laserfiche WebLink
A. Minimum scale is 1"=1000' showing the location and name of all arterial roadways <br />within one mile of the proposed construction, and all other roadways in the vicinity of <br />the proposed construction. Shading shall indicate the project area. This map is required <br />on the cover sheet or first sheet of all submittals, if no cover sheet has been used. The <br />vicinity map shall show all arterial roadways and major drainage ways. Section, <br />Township, and Range shall also be shown. <br />B. Minimum size of vicinity map shall be 10" x 10". <br />12.08.050 Key Map. <br />A. Minimum scale is 1"=500' showing the location and name of all roadways within and <br />adjacent to the proposed construction and all future roadways. Scale shall be indicated. <br />The key map shall be oriented consistent with detail in the sheet, i.e. same north. <br />B. The key map is to appear on every sheet showing proposed roadway, storm drainage or <br />grading improvements. The roadway or area that the design pertains to shall be shaded. <br />(Ord. 2015-010, 2015) <br />12.08.060 Title Block. <br />A title block is required on every sheet and cover sheet submitted for review and acceptance. The <br />subdivision name and filing number, Planned Unit Development name (if applicable); the type of <br />improvement; name, address, including zip code, and telephone number and name of the consulting <br />engineer; name, address, including zip code, telephone number and name of the developer or agent; <br />and sheet number (consecutive, beginning with the cover sheet) shall be included in the title block. <br />The title block shall be located in the extreme lower right hand corner, the right side margin, or <br />along the bottom edge of the sheet. <br />12.08.070 Acceptance Block. <br />All roadway construction plans, stormwater or other drainage improvement construction plans, and <br />privately or publicly maintained stormwater detention or retention facility construction plans must <br />show the acceptance signature of the designated representative of the Kittitas County Department of <br />Public Works. <br />A. The acceptance block shall be located in the lower right hand quadrant of the cover <br />sheet. <br />B. Acceptance block shall be as follows: <br />"These plans have been reviewed by Kittitas County Department of Public Works and <br />have been accepted for complying with the requirements of Kittitas County Road <br />Standards. <br />County Engineer Date <br />(Ord. 2015-010, 2015) <br />12.08.080 General Standards for Subdivision Final Construction Plans. <br />The following general standards shall be met for final construction plans. <br />A. All road and stormwater construction must conform to Kittitas County Road Standards <br />current at the time of application. Any construction occurring four years or more after <br />