Laserfiche WebLink
 Page 10 revised/updated by Kittitas County 6/21/2018 and erosion control measures must be in place prior to any clearing, grading, or construction. B.41 Washington Administrative Code (WAC) 173-400-040 requires that reasonable precautions be taken to prevent dust from leaving the site. Also, dust is prohibited from interfering unreasonably with the use and enjoyment of property, causing health impacts, or damaging property or business. The applicant states that Dunford Planned Unit Development is in agreement to this. Satisfied B.42 An approved private fire hydrant system shall be installed. The hydrant system shall be subject to plan review through the Fire Marshal’s Office and shall be subject to an annual Operational Permit. The responses to this requirement were inconsistent. Responses from B-42, A-2, and B-51 range from recognition of the intention to install a fire hydrant to a claim that sprinkler systems, although optional, will be installed in place of a hydrant. More clarity will be required related to this condition prior to final platting. Not Satisfied: See A(vii) B.43 Water storage and hydrant spacing shall comply with the International Fire Code. This requirement was not addressed in the documentation submitted by the applicant. This will need to be addressed further. Not Satisfied: See A(vii) B.44 The minimum flow requirements for the residential structures shall be no less than 1,000 gallons per minute. This requirement was not addressed in the documentation submitted by the applicant. This will need to be addressed further. Documentation of this condition must be met prior to final plat approval. Satisfied B.45 The minimum road width shall not be less than 26’ in width. The applicant states that the Dunford Planned Unit Development is in agreement to this unless circumstances warranted otherwise. This will be required for and reviewed prior to final plat approval. The condition requires road width to be no less than 26’ in width, the applicant with have to work with Public Works in the case this is not achievable and go through the necessary permitting requirements at that time. Satisfied B.46 A minimum of two fire apparatus access roads are required. The two access roads shall be not less than ½ the length of the maximum diagonal dimension of the property, measured in a straight line between accesses. The applicant responded to this requirement by stating that some existing WSDOT permits already provide access to the project site. The applicant will need to show in more detail how this condition has/will be met. Not Satisfied: Applicant will need to provide proof through a site plan or drawing demonstrating this condition has been met. B.47 If the Fire Marshal determines that Section D107 of the International Fire Code applies, the Fire Marshal shall determine whether or not any of the exceptions of D107.01 apply to this project. The applicant did not provide any documentation on this requirement. More information will be needed. Not Satisfied: Applicant must provide documentation from the fire marshal demonstrating that this condition has been met (staff is aware of ongoing conversations to reach resolution with this condition). B.48 No fire apparatus access lane shall have a slope greater than 12%. The applicant did not provide any documentation on this requirement. More information will be needed. This will be required for and reviewed prior to final plat approval. Satisfied B.49 “No Parking—Fire Lane” signs must be posted per Fire Marshal requirements. The applicant did not provide any documentation on this requirement. More information will be needed. This will be required prior to Satisfied Index #13