Laserfiche WebLink
16.20.020 Final plat general information. <br />1. The final plat shall be drawn on pe{yeste+{i{m plans in a neat and legible manner. <br />Z. The final plat shall be drawn to such a scale as to make a sheet eighteen inches by <br />twenty-four inches. Should this size sheet unduly congest the drawing, the plat may be <br />submitted on two or more sheets of the above dimensions. The perimeter of the <br />subdivision shall be depicted with heavier lines than appear elsewhere on the plat' A two <br />inch margin on the left edge, and a one-half inch margin on the other edges of the map <br />shall be provided. The scale shall be one (1) inch equals two hundred (200) feet, or <br />greater, unless otherwise approved by the director. <br />3. All lettering shall be printed with permanent ink. <br />4. Each sheef of the final plat shall contaln the subdivisions name at the top of the sheet in <br />large letters followed underneath with the section, township, range, county and state. <br />The space for recording the receiving number is in the upper right hand corner, sheet <br />numbers at the bottom of the sheets. <br />5. lt shall show all courses and distances necessary to re-stake any portion of said plat. <br />6. Required monuments shall be shown together with a legend of monuments on the face <br />of each Plat sheet. <br />fOrd. 2022*005, 2022; Ord.2005-31, 2005)