Laserfiche WebLink
16.20.020 Final plat general information. <br /> 1. The final plat shall be drawn on pe�mplans in a neat and legible manner. <br /> 2. The final plat shall be drawn to such a scale as to make a sheet eighteen inches by <br /> twenty-four inches.Should this size sheet unduly congest the drawing,the plat may be <br /> submitted on two or more sheets of the above dimensions.The perimeter of the <br /> subdivision shall be depicted with heavier lines than appear elsewhere on the plat- A two <br /> inch margin on the left edge,and a one-half inch margin on the other edges of the map <br /> shall be provided.The scale shall be one(1)inch equals two hundred (200)feet,or <br /> greater,unless otherwise approved by the director. <br /> 3. All lettering shall be printed with permanent ink <br /> 4. Each sheet of the final plat shall contain the subdivisions name at the top of the sheet in <br /> large letters followed underneath with the section,township, range,county and state. <br /> The space for recording the receiving number is in the upper right hand corner,sheet <br /> numbers at the bottom of the sheets. <br /> ecessary to re-stake any portion of said plat. <br /> 5. shall show all courses is shall shown stances n <br /> R monuments G. Required shown together i h a legend of monuments onthe face <br /> of each plat sheet. <br /> Ord.2022-005 2022;Ord. 2005-31, 2005) <br />