Laserfiche WebLink
16.20.020 Final plat general information. <br /> 1. The final plat shall be drawn on polyester fl'mplans in a neat and legible manner. <br /> 2. The final plat shall be drawn to such a scale as to make a sheet eighteen inches by <br /> twenty-four inches. Should this size sheet unduly congest the drawing, the plat may be <br /> submitted on two or more sheets of the above dimensions.The perimeter of the <br /> subdivision shall be depicted with heavier lines than appear elsewhere on the plat.A two <br /> inch margin on the left edge, and a one-half inch margin on the other edges of the map <br /> shall be provided. The scale shall be one (1) inch equals two hundred (200)feet, or <br /> greater, unless otherwise approved by the director. <br /> 3. All lettering shall be printed with permanent ink. <br /> 4. Each sheet of the final plat shall contain the subdivisions name at the top of the sheet in <br /> large letters followed underneath with the section, township, range, county and state. <br /> The space for recording the receiving number is in the upper right hand corner, sheet <br /> numbers at the bottom of the sheets. <br /> 5. It shall show all courses and distances necessary to re-stake any portion of said plat. <br /> 6. Required monuments shall be shown together with a legend of.monuments on the face <br /> of each plat sheet. <br /> (Ord. 2022-005. 2022; Ord. 2005-31, 2005) <br />