Laserfiche WebLink
2023 Docket Enabling Ordinance December 19, 2023 <br />Page 85 <br /> <br /> <br />F. All permits to remove, destroy or replace monuments shall be filed with the State <br />Department of Natural Resources pursuant to Washington Administrative Code. <br />G. For the establishment of new monuments, a record of survey shall be made in <br />accordance with the Survey Recording Act, Chapter 58.09 RCW, and filed with the <br />county auditor showing methods used to establish the monument’s position. <br />12.04.03.040 Range Points, Property Monuments, and Benchmarks. <br />The following criteria shall apply to all range points, property monuments, and benchmarks: <br /> <br />A. All monuments delineating right-of-way boundaries of property or witness <br />thereof shall be set in accordance with this section and all applicable State of <br />Washington laws and regulations. <br />B. Any "aliquot corner" (section corner, quarter corner, etc.), as described in the <br />Public Land Survey System, shall be monumented per Washington State Statutes and <br />stamped per the Manual of Survey Instructions. If such a corner falls within concrete or <br />asphalt, a monument case and cover shall be installed to protect and provide access to <br />said corner. <br />C. If so desired, the applicant may install monument cases and covers in asphalt or <br />concrete for property monuments, range points, benchmarks, etc., if the boxes comply <br />with Kittitas County standards. <br /> <br />Article IV. Geometric Design <br /> <br />12.04.04.010 Purpose. <br />The purpose of this article is to present Kittitas County criteria for the design of public and <br />private roads and streets. <br /> <br />12.04.04.020 Applicability. <br />This section applies to the design of streets and roads that meet the roadway classification <br />criteria as defined in KCC 12.03. Land use activity which requires road access shall be served by <br />a road that is built to the applicable county standards set forth in this section. The applicable <br />standard is determined by the density and type of land use, design speed, and traffic volume <br />(ADT). <br />