Laserfiche WebLink
Table 17.11.038(3)(b) Building setback and intensity standards - Nonresidential <br />zones. <br />Standard <br />C-H I-L I-H <br />DEVELOPMENT INTENSITY AND CONFIGURATION <br />Minimum lot area <br />None.. <br />None <br />None <br />Density, minimum (KCC 17.11.038(4)) <br />NA <br />NA <br />NA <br />Density, maximum (KCC 17.11.038(4)) <br />None <br />NA <br />NA <br />Maximum building height (see KCC 17.11.038(5) for height <br />exceptions) <br />35 ft <br />35 ft <br />None <br />BUILDING PLACEMENT (see KCC 17.11.038(5) through 17.11.038(10)) <br />Minimum front yard <br />10 ft <br />loft <br />loft <br />Garage front yard setback <br />22 ft <br />22 ft <br />22 ft <br />Minimum rear yard <br />None 2 <br />None 2 <br />None 2 <br />Minimum side yard <br />None 2 <br />None 2 <br />None 2 <br />17.11.038(3)(b)(i) Development condition footnotes associated with Table <br />1. Lot sizes may be variable provided they are sized and shaped sufficient to <br />accommodate permitted uses and conform to applicable design and density <br />standards. For areas within 100 feet of a residential zone, the maximum <br />building height shall be 35 feet. <br />2. Where the subject property borders a residential zone, the minimum side or <br />rear setbacks shall be the same as the adjacent residential zone. <br />3. Critical Areas as defined by Kittitas County Code. Calculations for Determining Maximum <br />Density - Gross Developable Acreage. <br />a. All site areas may be used in the calculation of the maximum allowed <br />residential density or project floor area except as outlined under the <br />provisions of subsection (13)(2) of this section. <br />b. Critical Areas as defined by Kittitas County Code shall not be credited <br />toward the maximum density or floor area calculations. Property used for <br />new roadways, trails, stormwater facilities, or other features used by <br />residents may be counted as part of the site area for density calculations. <br />Property transferred to the city for the construction of public roadways or <br />other public feature shall be counted as part of the site area if the city and <br />property owner reach such an agreement as part of the transfer. <br />4. Density Calculations. <br />a. Maximum density for an individual site shall be calculated by multiplying <br />the gross developable acreage by the applicable number of dwelling units. <br />