Kittitas SWMP Update_Approved_(2020-07-09)

Home Browse Search

KCHD ORDINANCE 1999- 27 SOLID WASTE REGULATIONS (14) Topography of the site and drainage patterns for both pre- and post-development conditions. b. Preliminary engineering report/plans and specifications and development and operation plans are subject to the requirements of WAC 173-304-600(3)(b)(ii), and shall include, but not be limited to: (1) How the facility will meet the locational standards of WAC 173-304-130; (2) Relationship of the facility to the most recently approved Kittitas County Solid Waste Management Plan, and the basis/calculations for determining the facility's life; (3) The design of bottom and side liners, and final cover system; (4) Identification and analysis of borrow sources for liner construction, and daily and final cover; (5) Interim/final leachate collection, treatment and disposal methodology; (6) Ground water monitoring; (7) Landfill gas control and monitoring; (8) Stormwater surface run-off quality and quantity control, discharge, and monitoring; (9) Trench design, fill methods, elevation of final cover and bottom liner, and equipment requirements; and (10) Closure/post-closure design, construction, maintenance and land use. c. The operation plan is subject to the requirements of WAC 173-304-600(3)(b)(iii), and shall address, at a minimum: (1) Operation and maintenance of leachate collection, treatment and disposal systems; (2) Operation and maintenance of landfill gas control systems; (3) Operation, maintenance, and monitoring plans for ground water, surface water and landfill gases to include sampling technique, frequency, handling and analyses requirements; (4) Plans for handling solid wastes on-site including plans for handling asbestos and problem wastes; (5) Safety and emergency plans; (6) Routine filling, grading, cover and housekeeping, including dust control and blowing litter; (7) Record system to address records on weights and volumes of each waste stream type, number of vehicles and the types of waste received; (8) A method to perform an annual waste capacity analysis study of the site to determine total amount of the site capacity filled to date, and total site life remaining based upon the frequency, volumes, and compaction effectiveness of solid wastes brought to the site; (9) Vector control plans;