Laserfiche WebLink
2. New on-site systems should only be allowed in limited areas for small scale development <br />where public sewers are not feasible. <br />3. On-site wastewater treatment should be designed and located to protect water quality in <br />lakes, streams, wells and aquifers, in compliance with District standards. <br />4. Operation and maintenance standards should be established for all areas served by on-site <br />systems. Special programs, including inspections and regular pumping of tanks, should be <br />established in all areas with a high risk of system failure. <br />5. On-site systems that create health or pollution problems should be repaired or replaced. <br />Provision of public sewers to these areas should be considered an option . <br />6. On-site wastewater systems should be monitored for evidence of existing or potential <br />failures and the data should be used to correct problems and prevent future problems. <br />7. Solid waste should be handled and disposed in ways that minimize land, air and water <br />pollution, and protect public health. <br />7.1.5 Surface Water Management <br />1. Surface water management should integrate with and protect natural drainage systems <br />wherever possible. <br />2. A watershed approach to surface water management should be implemented which <br />provides for multiple uses including recreation, fish and wildlife enhancement, flood <br />protection, erosion control and open space. <br />3. Stormwater facilities should be funded through an adequate and equitable set of user <br />charges on contributing and benefiting properties. Stormwater facilities required of new <br />development should be designed and built for low-cost, long-term maintenance. <br />4. Design of stormwater management systems should recognize the impacts of rapid snow <br />melt on intensity and volume of runoff. <br />5. Consistent with other considerations, such as snow removal, maintenance and aesthetics, <br />the amount of hard surfaced areas for parking and roads should be minimized to the extent <br />possible. <br />6. Clearing and grading activities should be regulated to minimize the removal of surface <br />vegetation, which alters natural drainage characteristics , increases runoff and potential for <br />erosion. <br />7.1.6 Energy and Telecommunications <br />1. Energy, utility and telecommunications distribution and transmission facilities (for example, <br />substations, pump stations, major power lines and pipelines, transmission/reception <br />towers) should be underground whenever feasible and should not be located in residential <br />areas unless other alternatives are not feasible. <br />2. Siting decisions for energy and telecommunications facilities should be based on applicable <br />regulations and the following factors: <br />Kittitas County <br />Comprehensive Plan <br />December 2016