Laserfiche WebLink
allow for it then look at the Kiser Speedmaster and its competitors. I will <br />show you the difference in all of them if you decide to go that way. <br />General Maintenance for Bloom Arena <br />I would recommend that for any cutting that is held in the Bloom Arena <br />that the following directions be utilized. <br />I- Water enough so the arena is not dusty then level. <br />II- Water again and let set for 4 to 6 hours. <br />III- Pack arena with the old water trucks. Make sure you do not turn on the <br />arena, drive straight back and forth. <br />IV- Put sand on top of packed arena being careful not to disturb packed <br />base. Do not turn on base at all, stay on sand as you spread it. <br />Sand Removal <br />Do not mix sand into footing while removing it. The best way is to use a <br />box blade to pull sand to one area to load it. Make sure you do not spin <br />tires or do anything that will mix sand into arena footing. The only sand <br />that should be used in the arena is the Black sand from Callahan pit. This is <br />the only sand that should be used for any purpose and your facility. <br />Kiser Arena Specialists * 243 CR 281 * Gainesville, TX 76240 * Office 940-665-8058 <br />www.kiserarenaspecialists.com * E-mail: bkiser@kiserarenaspecialists.com <br />