PD-17-00001 Marian Meadows Full Record with Index (2)

Home Browse Search

4 with densities within Airport Safety Zones (ASZs) higher than is recommended under the Program. County Response Kittitas County Public Works has reviewed the proposal for compliance with KCC 17.58 Airport Zone, and related conditions of approval are listed below. In addition, the Applicant is encouraged to contact the WSDOT Aviation Division to explore opportunities for mitigation measures to allow increased density within the Airport Safety Zones. Such discussion and agreement can be a condition in a Development Agreement. Kittitas County Public Works In a comment letter dated July 28th, 2017 Kittitas County Public Works lists the following recommended conditions of approval: 1) The following conditions apply and must be completed prior to final approval of this project. A performance guarantee may be used, in lieu of the required improvements per the conditions outlined n KCC 12.01150. (See Condition # 11) 2) The division of land is vested, and shall conform to the Current Kittitas County Code Chapter 12 Road and Bridge Standards dated December 15, 2015. (See Condition # 12) 3) The number of units associated with the campsites and RVs shall be identified in order to determine road standards. (See Condition # 13) 4) The Traffic Impact Analysis for the will suffice for this proposal. (No condition warranted) 5) Loop roads will satisfy the second access requirement as long as both connecting points loop back to a road built to a Public Road Standard. Loop Roads are required to have two separate accesses to a Public Road. Public Roads are not capped by number of lots/units that can access. (See Condition # 14) 6) The face of the plat shall show how lot 19 will be accessed. (See Condition # 15) 7) Plans for on-site stormwater and construction stormwater shall be submitted in accordance with Current Kittitas County Road and Bridge Standards dated December 15, 2015. (See Condition # 16) 8) Road plans shall be submitted in accordance with Kittitas County Road and Bridge Standards dated December 15, 2015. (See Condition # 17) 9) Locations identified for snow storage shall be designed to accommodate storage for 84 inches of annual accumulation for the square footage of all roadways and parking areas. Snow storage areas accommodating public roadways shall be included in the public right of way dedication. (See Condition # 18) 10) Roadways brought on the system by the County, following the process as outlined in Kittitas County Code Chapter 12, shall have said right of way dedicated to the county on the plat. (See Condition # 19) 11) Road naming applications for all new roadways will need to be completed prior to final approval. The new established road names will need to be shown on the face of the plat. (See Condition # 20) 12) Plat notes shall reflect the following: a. Kittitas County will not accept private roads for maintenance as public streets or roads until such streets or roads are brought into conformance with current County Road Standards and formally adopted by the Kittitas County Board of County