Laserfiche WebLink
<br /> <br />Kittitas County Shoreline Master Program <br />Chapter 6 103 <br />March 7, 2016 <br />Kittitas County Board of County Commissioners Shoreline Master Program Adopting Ordinance <br />Kittitas County Shoreline Master Program Exhibit A | March 2016 | Page 103 of 339 <br />i. Submit an operations and site plan demonstrating: <br />(1) Location and design of fuel handling and storage facilities to minimize <br />accidental spillage and protect water quality; <br />(2) Proper water depth and flushing action for any area considered for overnight <br />or long-term moorage facilities; <br />(3) Adequate facilities to properly handle wastes from holding tanks; <br />(4) Suitable environmental conditions and shoreline configuration; <br />(5) Adequate access located away from the immediate water's edge; <br />(6) Adequate parking and restroom facilities located landward of the shoreline <br />buffers shown in Section 5.5.B.1. <br /> <br />4. Boat launch ramps shall comply with Section 6.5.B.3.a, b, c, f, g, and h, and shall <br />meet the following: <br />a. Minimize the area disturbed by boat launch construction. <br />b. Submit an operations and site plan demonstrating: <br />i. Vegetation management, mowing and trimming; <br />ii. Litter pick-up and disposal; <br />iii. Appropriate directional and regulatory signs; <br />iv. Adequate access located away from the immediate water's edge; <br />v. Adequate parking and restroom facilities located landward of the shoreline <br />buffers shown in Section 5.5.B.1. <br /> <br />5. Piers, ramps, and docks permitted on lakes and the Columbia River shall meet the <br />following dimensional standards: <br />a. To prevent damage to shallow water habitat, piers and/or ramps shall extend at <br />least forty (40) feet perpendicular from the OHWM. Docks shall be positioned at <br />least forty (40) feet horizontally from the OHWM. <br />b. Float components for single party docks shall not exceed the dimensions of eight- <br />by-twenty (8-by-20)-feet or an aggregate total of one hundred sixty (160) square <br />feet for all float components. Float components for joint-use docks shall not exceed <br />the dimensions of eight-by-forty (8-by-40)-feet or an aggregate total of three <br />hundred twenty (320) square feet for all float components. <br />c. Piers and ramps shall be no more than four (4) feet in width for single or joint-use <br />docks. Greater widths may be permitted for community, public, or commercial <br />docks where use patterns can justify the increase. <br />d. The bottom of the pier or bottom of the landward edge of the ramp shall be <br />elevated at least two (2) feet above the plane of OHWM. <br />e. Floats shall not be located in shallow water habitat where they could ground or <br />impede the passage or rearing of any life stage of salmonid. Floats shall be in at <br />least ten (10) feet of water. <br />f. Grating shall cover the entire surface area of the pier, ramp, and/or float. The open <br />area of grating shall be at least fifty percent (50%) as rated by the manufacturer.